Columbia Plywood Amends Permit In NC, Hopes To Add AirBurners FireBox

The North Carolina Department of Environmental Quality’s Division of Air Quality (DAQ) is accepting public comment on a draft air quality permit modification for Columbia Plywood Corp.—Columbia Carolina Division, the company’s plywood manufacturing facility in Old Fort, NC.

If approved, the modification would allow Columbia Plywood to install an air curtain incinerator unit from AirBurners at the facility to burn its wood waste for disposal—increasing potential emissions thresholds, thus requiring a Title V air quality permit.

AirBurners incinerators, branded as FireBox, were designed principally as a pollution control device for open burning. The primary objective of an air curtain machine is to reduce the particulate matter, which results from burning clean wood waste. Using a technology called “air curtain,” the smoke particles are trapped and reburned, reducing them to an acceptable limit per EPA guidelines.

Clean wood waste is loaded into the FireBox and an accelerant is used to ignite the pile. The air curtain is not engaged until the fire has grown in strength, usually after 15 to 20 minutes. Once engaged, the air curtain then runs at a steady state throughout the burn operation, and the waste wood is loaded at a rate consistent with the rate of burn. The smallest machine offered by AirBurners burns at a rate of 1-2 tons per hour, with the largest burning in excess of 10 tons per hour.

All public comments made to the DAQ before September 11, 2025 will be considered before a final decision on the proposed permit is made.

Latest news

Late 2022 Purchases Put Enviva In A Bind

“Our future profitability and liquidity are expected to be negatively impacted by the following matters which have resulted in substantial doubt about the company’s ability to continue as a growing concern,” states Enviva in its 10-Q filing with the Securities and Exchange Commission upon releasing its third quarter earnings report, which noted that Enviva incurred net losses of $258 million for the nine…

read more

Morbark Unveils BVR, TW Series Brush Chippers

Morbark has unveiled the all NEW “BVR” line of hand-fed brush chippers at this year’s TCI Expo, in St. Louis, Mo. Alongside the BVR lineup, visitors found 6- and 8-in. brush chippers from Timberwolf. Timberwolf, an Alamo Group company, is headquartered in Suffolk, UK, and will be marketed in the U.S. as the Morbark TW series, beginning the first quarter of 2024…

read more

Machine Innovator Neil Peterson Dies

A memorial service was held October 29 in Pleasant Hill, Ore. for forest machinery pioneer and innovator Neil Peterson, the driving force behind Peterson Pacific Corp. that revolutionized in-woods and mobile delimbing, debarking and chipping. Peterson was not just a pioneer in his field but also a generous philanthropist, a guiding force for his team, and a beacon of opportunities for his employees…

read more

Sustainable Forests Report Has Mixed Results

Released in September, the “National Report on Sustainable Forests, 2020” from the U.S. Dept. of Agriculture (USDA) and Forest Service (FS) shows both good and challenging trends as the nation’s forestland owners seek sustainable ownership and management options. The fourth such effort since 1997, the report is 60 pages…

read more

Find Us On Social

Subscribe to Our Newsletter

Wood Bioenergy News Online hits the inboxes of subscribers in the wood-to-energy sectors.

Subscribe/Renew

Wood Bioenergy is published and delivered worldwide 6 times per year. Free to qualified readers in the U.S. Subscribers outside the U.S. are asked to pay a small fee.

Advertise

Complete the online form so we can direct you to the appropriate Sales Representative.