Columbia Plywood Amends Permit In NC, Hopes To Add AirBurners FireBox

The North Carolina Department of Environmental Quality’s Division of Air Quality (DAQ) is accepting public comment on a draft air quality permit modification for Columbia Plywood Corp.—Columbia Carolina Division, the company’s plywood manufacturing facility in Old Fort, NC.

If approved, the modification would allow Columbia Plywood to install an air curtain incinerator unit from AirBurners at the facility to burn its wood waste for disposal—increasing potential emissions thresholds, thus requiring a Title V air quality permit.

AirBurners incinerators, branded as FireBox, were designed principally as a pollution control device for open burning. The primary objective of an air curtain machine is to reduce the particulate matter, which results from burning clean wood waste. Using a technology called “air curtain,” the smoke particles are trapped and reburned, reducing them to an acceptable limit per EPA guidelines.

Clean wood waste is loaded into the FireBox and an accelerant is used to ignite the pile. The air curtain is not engaged until the fire has grown in strength, usually after 15 to 20 minutes. Once engaged, the air curtain then runs at a steady state throughout the burn operation, and the waste wood is loaded at a rate consistent with the rate of burn. The smallest machine offered by AirBurners burns at a rate of 1-2 tons per hour, with the largest burning in excess of 10 tons per hour.

All public comments made to the DAQ before September 11, 2025 will be considered before a final decision on the proposed permit is made.

Latest news

Drax Group Allies With Molpus Woodlands

Drax Group Allies With Molpus Woodlands Carbon removals and renewable energy company Drax Group has partnered with Mississippi-based Molpus Woodlands Group in an agreement that will provide Drax with an option to purchase sustainably sourced woody biomass to fuel its...

read more

Georgia Ports Continues Container Expansion

Georgia Ports Continues Container Expansion Georgia Ports Authority approved contracts totaling $65.6 million for container yard work at the Port of Savannah’s Ocean Terminal, a 200-acre facility just downriver from GPA’s main container port. The board approved three...

read more

Stela Belt Dryer BT 8400

Stela Belt Dryer BT 8400 The Stela Belt Dryer BT 8400 is the next generation of belt dryers solving the biomass drying challenge. Stela Drying Technology, a global leader in low-temperature belt drying, continues to push boundaries with innovative solutions across a...

read more

Michigan Rejects Biomass Plant Closure Request

Michigan Rejects Biomass Plant Closure Request The Michigan Public Service Commission (MPSC) recently rejected requests by Consumers Energy to end contracts and close two wood-fired biomass power plants in Cadillac and Lincoln, Mich. The company was looking to close...

read more

Find Us On Social

Subscribe to Our Newsletter

Wood Bioenergy News Online hits the inboxes of subscribers in the wood-to-energy sectors.

Subscribe/Renew

Wood Bioenergy is published and delivered worldwide 6 times per year. Free to qualified readers in the U.S. Subscribers outside the U.S. are asked to pay a small fee.

Advertise

Complete the online form so we can direct you to the appropriate Sales Representative.